>I set my compressor plumbing the way TIP Tools suggests. I used 3/4"
>galvanized pipe with risers and drains as they describe. I have attached a
>link to their web page that describes the plumbing set up through a link
>about half way down the page at number 5. The link was not working when I
>tried so you may want to give it a try yourself.
The reason the link on item 5 is not working is because its missing the
"www" in the address. I went to the following link as suggested
http://www.tiptools.com/tech_line/compressors/air_consumption.html
and on item 5 there is a link which SHOULD look like this to work
http://www.tiptools.com/compressors/piping_diagram.pdf
but in the document its missing the "www""
mike
~~~~~ I'd rather be sailing ~~~~~~~and \/ \/ ~~~~~~~~~~~~~~
Mike Rambour .oooO Oooo.
Bug Writer er...Programmer ( ) ( )
\ ( ) /
\_) (_/
webmaster@b2systems.com
***********************************************************************
If you want to learn more about the ULTIMATE BRITISH sports car, then
take a look at http://www.singercars.com/
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
|