Awesome site! Thanks, Bob. The well nuts would make the steel plates
stand off the aluminum, so they wont work, but on that site there was
this page http://www.thread-rite.com/plastic/index.htm which is sure to
have exactly what I need, once I take delivery and find out the hole
size. Now I gotta go find my mastic.
Thanks again,
Jon
Bob Kegel wrote:
>>There are holes that are predrilled, but I think they are too
>>large for rivets because they were designed for screws.
>
>
> Something like this: http://www.thread-rite.com/pop_nuts/well_nut_sleve.htm
> seems to address both the oversize hole and galvanic action issues.
>
> Bob Kegel
> Aberdeen, WA
> _______________________________________________
> Support Team.Net http://www.team.net/donate.html
>
> You are subscribed as jdrush@enter.net
>
> Shop-talk mailing list
>
> http://autox.team.net/mailman/listinfo/shop-talk
>
> http://www.team.net/archive
_______________________________________________
Support Team.Net http://www.team.net/donate.html
Shop-talk mailing list
http://autox.team.net/mailman/listinfo/shop-talk
http://www.team.net/archive
|