Scott,
You probably will need to run the opener a few inches down the track with the
motor, stop it, and then re-engage the pin there. At the stop there generally
is some "interference fit" issues. I had the same problem.
------Original Message------
From: scott.hall@comcast.net
Sender: shop-talk-bounces@autox.team.net
To: shop-talk@autox.team.net
Subject: [Shop-talk] Craftsman garage door openers
Sent: Mar 21, 2010 8:39 AM
This should be simple, I'd think. The power went out last week at the house. I
pulled the cord on the opener to release it from the carriage on the track. Now
I can't get it to re-engage.
I'm starting to worry myself a little but--I can rebuild an engine, but I can't
swap the face shields on my Arai, and I can't re-engage a garage door.
_______________________________________________
Shop-talk@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.96
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe/Manage:
http://autox.team.net/mailman/options/shop-talk/dirtbeard@pacbell.net
best,
Doug Shook (Blackberry)
323.286.6115
_______________________________________________
Shop-talk@autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation $12.96
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|