A while back there was a thread about adding a pcv valve to a Weber setup by
tapping a port into the Canon manifold below the carb itself. I've looked
all mornings for the email in the archives that had the photos and the parts
list, with no luck. I'm about to swap my stock header and cat converter for
a HPC coated 4-2-1 stainless steel header, and now is the time to make the
connection. Does anyone have the info on the part number for the pcv valve
that will work with a 1980 Spit with a Weber down draft? Is it still a good
idea? My valve cover vent now runs to a carbon canister after a "T" to the
bottom of the air cleaner.
Also, I purchased a couple of those bonnet locks from VB a while ago, but
there were no instructions as to the preferred location for the locks. Any
ideas? Any experiences?
Dan Parrott
Savannah, Ga
1980 Spit "PJ"
/// spitfires@autox.team.net mailing list
/// or try http://www.team.net/cgi-bin/majorcool
/// Archives at http://www.team.net/archive
|