That is great news, Roger. I just got a workshop manual to check that out. I
can see that is the way to go. I am still tempted to do a conversion to a
Toyota or Nissan drivetrain or whatever some one out there might recommend.
Thanks
Sent from my iPad
On Jul 29, 2013, at 4:27 PM, Roger Elliott <elliottr@rmi.net> wrote:
> If that is all that is wrong, you can drop the oil pan and the front main
bearing and put a new ones in. They come in different thicknesses. I think
SpitBits has the wides selection of thicknesses. Goodparts also has a good
selection and his are hardened.
>
> Roger
>
>
> On 07/29/2013 06:07 PM, Hans wrote:
>> OK, I misunderstood when you said "measure how far it travels with clutch
>> depressed"
>> i measured the end float at the pulley to be about an eight of an inch!
Wow,
>> it sounds like the thrust washer dropped out altogether as Donald Locker
>> suggested. It would explain the suddenness. It being hot was coincidental.
>> I guess there is no easier fix than an overhaul(?)Too bad, it is running
>> really well with good compression on all cylinders in spite of all the
>> caliifornia smog crap on it.
>> Thanks again,
>> Hans
_______________________________________________
Spitfires@autox.team.net
Archive: http://www.team.net/archive
|