spridgets
[Top] [All Lists]

Re: Tires ... etc !

To: "Editors, Molecular Vision" <jboatri@emory.edu>, <chuckc@ibm.net>, <spridgets@Autox.Team.Net>
Subject: Re: Tires ... etc !
From: "Larry and Sandi Miller" <millerls@email.msn.com>
Date: Thu, 18 Jun 1998 13:10:47 -0700
Reply-to: "Larry and Sandi Miller" <millerls@email.msn.com>
Sender: owner-spridgets@Autox.Team.Net
Be aware that one side is left hand and the other is right hand threads.

LM
-----Original Message-----
From: Editors, Molecular Vision <jboatri@emory.edu>
To: chuckc@ibm.net <chuckc@ibm.net>; spridgets@Autox.Team.Net
<spridgets@Autox.Team.Net>
Date: 18 June, 1998 11:31 AM
Subject: Re: Tires ... etc !


>At 1:08 PM -0500 6/18/98, Chuck Ciaffone wrote:
>
>
>> Jeff,
>>
>> Thanks for the help!
>>
>> What size socket will I need to pull the hub?
>> It's a little bigger than the 46mm VW hum socket
>> I have lauying around.
>>
>> chuck
>>
>> --
>> =====================================================
>>
>> chuck ciaffone chuckc@ibm.net
>
>
>There is a big keyed washer that sits inboard of the big nut. It has one
>side folded flat against a flat of the big nut. This keeps the nut from
>spinning off. You need to carefully chisel the bent washer back off of the
>nut. The nut should then be pretty easy to unscrew. I used a pair of vise
>grips, but only because they were the only thing I had big enough to get
>around the nut, plus my nut was  in bad shape and I was going to replace it
>anyway.
>
>Again, you may not need to pull the hub. Try replacing the O-ring and paper
>gasket first.
>
>Jeff
>
>
>
>Jeffrey H. Boatright, PhD
>Senior Editor, Molecular Vision
>http://www.molvis.org/molvis
>Mailto:jboatri@emory.edu
>404-778-4113
>
>
>
>




<Prev in Thread] Current Thread [Next in Thread>