Re: Engine Pulling

[Lancer7676@aol.com]

In a message dated 2/25/99 12:40:09 PM Eastern Standard Time, jurban@p3.net
writes:

<< Most of the advice is to tie the chain to the head/rocker studs(no chain
 knots, but using an metal angle).  Can these studs take the weight?? >>


Nah Jason--Much better (I think) to bolt the chain into the generator bolt on
the right side and the rear exhaust stud on the left.  Gives good balance and
you are pulling sideways on a substantial nut/stud instead of straight up on a
nut.

Worked for me!

--David