spridgets
[Top] [All Lists]

Re: Heater Control Valves

To: pixelsmith@gerardsgarage.com, JZIMMERM@exch.co.albemarle.va.us, spridgets@autox.team.net
Subject: Re: Heater Control Valves
From: Daniel1312@aol.com
Date: Wed, 5 May 1999 16:26:34 EDT
Reply-to: Daniel1312@aol.com
Sender: owner-spridgets@autox.team.net
In a message dated 05/5/1999  8:03:50PM,  pixelsmith@gerardsgarage.com writes:

<< I'm not sure that the premise that the valve being closed causes any
 cylinder overheating problem, at least I've never heard this before. There
 is still a water jacket around the last cylinder allowing water to
 circulate. The valve just allows water to be diverted from the cylinder
 head to the core. Since race engines have this opening capped, I can't
 imagine that this is really a problem.
  >>
I'm sure it does and I've heard it a lot.  I have seen racers with the 
opening capped and they have had problems (duh).

Yes, there is coolant around the cylinder but what about the combustion 
chamber?

The valve doesn't just allow water to circulate to the core (which in itself 
sheds heat) but having been through the core it returns to the front of the 
engine (circulates).

But to put all this in perspective what can cause problems on highly tuned 
road engines is different from a racer (which never has to idle in traffic 
and always gets a good flow of air) and different again from a standard 
engine (just doesn't make much power and therefore heat).

Other views? experiences?


Daniel1312

<Prev in Thread] Current Thread [Next in Thread>