I do have an extra 13B rotary sitting in the garage....... but I planned to
put it into the Nash Metropolitan, once I figure out how to get some bigger
brakes on it!
bruce@woodward-realty.com
----- Original Message -----
From: Keith Turk <kturk@ala.net>
To: Bruce Woodward <bruce@woodward-realty.com>
Sent: Thursday, May 13, 1999 11:57 PM
Subject: Re: first motion shaft bushing
Hey if it doesn't work... you can always pull the MOTOR and STICK A SMALL
BLOCK CHEVY IN... ( in know quit that... sorry it's in my Blood this week)
Keith
I ain't got a clue but I am having a hell of a time proving it...
----------
> From: Bruce Woodward <brucewoodward@kconline.com>
> To: Keith Turk <kturk@ala.net>
> Subject: Re: first motion shaft bushing
> Date: Thursday, May 13, 1999 7:53 PM
>
> thanx Keith. I was concerned it was tightly fitted in the "socket", but
> your comments as well as ron's has me more confident that it will not be
an
> issue. Again, thanx for your "input". Arrr, arrr, arrr.
>
>
> bruce@woodward-realty.com
>
> ----- Original Message -----
> From: Keith Turk <kturk@ala.net>
> To: Bruce Woodward <brucewoodward@kconline.com>; Spridgets
> <spridgets@autox.team.net>
> Sent: Thursday, May 13, 1999 11:18 PM
> Subject: Re: first motion shaft bushing
>
>
> Yes.... Pack it in wheel bearing Grease....and then put the Clutch
> alignment tool in and tap on it with a hammer.. the grease will hydraulic
> it out.... Trust me it works for me... hmmm
>
> Keith Turk
> Austin Healey 100 / Bugeye / Box Sprite / Bonneville Land Speed Racer
> Camaro ( D Gas Altered )
>
> ----------
> > From: Bruce Woodward <brucewoodward@kconline.com>
> > To: Spridgets <spridgets@autox.team.net>
> > Subject: first motion shaft bushing
> > Date: Thursday, May 13, 1999 6:59 PM
> >
> > I'm getting ready to pull motor on my 1098cc Mark II Midget and renew
the
> > first motion shaft bushing, the little bronze bushing that is inset in
> the
> > crankshaft and centers the input shaft of the transmission.
> >
> > My question: None of the local supply houses have an expanding bushing
> > puller small enough (1/2" inside diameter) for purchase. Anybody got
any
> > secrets to alternative removal of this bushing?
> >
> >
> > bruce@woodward-realty.com
> >
> >
>
>
|