| To: | Gary Speckman <speckman@coredcs.com> |
|---|---|
| Subject: | Re: Rubber Bump Stop Patent #55 |
| From: | Frank Clarici <spritenut@Exit109.com> |
| Date: | Fri, 02 Jul 1999 21:16:10 -0400 |
| Cc: | spridgets@autox.team.net |
| Organization: | Positive Earth Drivers Club |
| References: | <199907021413.JAA23855@chaos.coredcs.com> |
| Reply-to: | Frank Clarici <spritenut@Exit109.com> |
| Sender: | owner-spridgets@autox.team.net |
Gary Speckman wrote: > > He also said 1/4" will lower the car quite a bit, this is true, so dont be > tempted to go overboard. Gar, If you get new (chinese steel) rear springs, you can wedge then 6-8" and it will still be too high. Seriously, Gary is right about the 1/4" or so, I think I wedged mine about 3/8", and I had the over sprung leafs. Good point on the bump stops too. I did npt cut mine down and I often felt them bottom out on the road. -- Frank Clarici Toms River, NJ Bugeye Sprite 67 Sprite 59 A40 http://www.exit109.com/~spritenut/ |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Re: LBC clunker(driveshaft bolts), Frank Clarici |
|---|---|
| Next by Date: | Re: Porter book, FRED TALASCO |
| Previous by Thread: | Rubber Bump Stop Patent #55, Gary Speckman |
| Next by Thread: | Re: Rubber Bump Stop Patent #55, Mike Gigante |
| Indexes: | [Date] [Thread] [Top] [All Lists] |