In a message dated 1/18/00 12:04:37 PM, mhanna@ball.com writes:
<< , I'm restoring the
"High beam dip switch" presently, and the concourse standards say that the
fiber board (cardboard) insulator that goes between the dip switch mounting
plate and floor board (Toe Board) was painted red. Red ? What general shade
of red ? Glossy or flat ? Have any of you folks seen this red part ? Just
how red is it ? >>
Ours is forty years old but would say it's color is about the same as light
rust. Have not seen it in about three years and you know what they say about
getting old <BG>
Bob and Annice
1960 Sprite (Mk IV indiguise)
1966(7) Sprite Mk III (in progress)
|