After the alcohol, flush with DOT4.
--- DLancer7676@cs.com wrote:
> In a message dated 2/21/2000 1:42:17 AM Eastern
> Standard Time,
> milesgrogg@wwnet.net writes:
>
> << At the very least you will
> probably have dramatically altered the boiling
> point of the system fluid. I
> believe the proper choice is to bled the old fluid
> while replacing with
> fresh brake fluid thus removing any contaminates
> (absorbed water most
> likely). >>
>
> Mike makes sense on this to me. Since water is the
> basic culprit in failure
> of brake lines, it just doesnt make sense to add a
> water-based, liquid with a
> high concentration of water to the system. Maybe try
> a 190 proof grain which
> has only 5% water--but then you would have to
> refrain from drinking it <G>
> and it is expensive for this purpose.
>
> --David C.
>
=====
Ron Soave
"Here we are now, entertain us!"
IGNORE THE YAHOO MESSAGE BELOW!!!!!
Do You Yahoo!?
|