spridgets
[Top] [All Lists]

Re: Valve Seal O-Rings

To: mgs@autox.team.net, spridgets@autox.team.net, fpixley@kingston.net
Subject: Re: Valve Seal O-Rings
Date: Wed, 15 Mar 2000 09:35:18 -0800 (PST)
Fred,

I may be mistaken, but I don't think the O-rings are intended to be use as 
seals. I think a lot of kits include them to be used to be put over the valve 
stems to 'temporarily' hold the valves on the head, so that you can get the 
springs and retainers on.

 - Bryan
 
>To: "mgs-digest list" <mgs@autox.team.net>, "spridgets-digest@autox.team.net" 
<spridgets@autox.team.net>
>Subject: Valve Seal O-Rings
>MIME-Version: 1.0 charset="iso-8859-1"
>X-Priority: 3
>X-MSMail-Priority: Normal
>X-MimeOLE: Produced By Microsoft MimeOLE V5.00.2314.1300
>
>I've just rebuilt a cylinder head on my Mini.  It's a 998 and had no obvious
>seals installed previously.  I realize they are not required on the exhaust
>valves, but the gasket kits include 8 o-ring seals.  I installed them under
>the retainers and they position themselves about half-way between the top of
>the guide and the retainer.
>
>I can't see how this will prevent much oil entering the guides although it
>might help somewhat.  Have I installed them in the correct location?
>
>
>Fred Pixley
>Napanee, Ontario, Canada
>fpixley@kingston.net
>
>


<Prev in Thread] Current Thread [Next in Thread>