spridgets
[Top] [All Lists]

Re: 5-speed coming soon!

To: grbyrns@ucdavis.edu, spridgets@autox.team.net, geopro@cyberdrive.net
Subject: Re: 5-speed coming soon!
Date: Tue, 20 Jun 2000 10:52:28 -0700 (PDT)
Glen,

BTW - Which rear oil seal did you use??

 - Bryan
 
>To: "Glen Byrns" <grbyrns@ucdavis.edu>, <spridgets@autox.team.net>
>Subject: Re: 5-speed coming soon!
>MIME-Version: 1.0 charset="Windows-1252"
>X-Priority: 3
>X-MSMail-Priority: Normal
>X-Mimeole: Produced By Microsoft MimeOLE V5.00.2919.6600
>
>Keep us informed Glen. We're counting on you !
>George Procyshyn
>'58 AN5
>
>----- Original Message -----
>From: "Glen Byrns" <grbyrns@ucdavis.edu>
>To: <spridgets@autox.team.net>
>Sent: Tuesday, June 20, 2000 12:31 PM
>Subject: 5-speed coming soon!
>
>
>> Well..  Paul's Morriservice 5-speed kit arrived last night
>and the race
>> begins to get it in before the Chico meet this weekend.
>It looks simple
>> enough, all parts look well thought out and well
>engineered.  My flywheel
>> came back looking better than it ever has.
>>
>> U-joint/drive shaft modification was easy, cutting the
>hole for the starter
>> was tedious but simple.  The new seal at the back of the
>tranny is easy,
>> installing the rear tranny mount and angle drive for the
>speedo was also
>> quite easy.  The clutch slave mounting system took a
>minute to figure out
>> (and a very small peek at the directions) but is now in
>place and looks very
>> good.
>>
>> The big trick is to get it done with the little bit of the
>evening that is
>> left after a day of work, dinner, family time, and reading
>one chapter of
>> Harry Potter per evening to my younger daughter.   That
>means I get to work
>> each evening at about 9:30 and go at it until the 11:00
>news.
>>
>> Regards,
>> Glen Byrns
>> '59 bugeye
>>
>>
>>
>


<Prev in Thread] Current Thread [Next in Thread>