spridgets
[Top] [All Lists]

UK-spec Midget 1500 hose question

To: "spridgets@autox.team.net" <spridgets@autox.team.net>
Subject: UK-spec Midget 1500 hose question
Date: Wed, 06 Sep 2000 18:00:48 -0400
  I am trying to make my Midget 1500 roughly UK
spec using bits from the UK.

  Everything is fine except I am having trouble
doing the heater hose routing, I have one extra end.

  Can somebody describe the hose routing in the
rear area of the block, around the heater input
and shut off faucet?

  I have the following ends to connect:

  - Heater outlet
  - Heater inlet
  - Faucet inlet
  - Faucet outlet
  - Block connection
  - Inlet manifold top connection
  - Inlet manifold bottom connection
  - pipe-under-manifold rear connection
  - pipe-under-manifold side connection

  ...and notice my dilemna, there are nine connections
to be made, so I'm going to have one extra.

  Is there a Tee fitting that goes somewhere in
mid-hose?

-- 
Trevor Boicey, P. Eng.
Ottawa, Canada, tboicey@brit.ca
ICQ #17432933 http://www.brit.ca/~tboicey/
Only one of the three Rs actually begins with R.

<Prev in Thread] Current Thread [Next in Thread>