spridgets
[Top] [All Lists]

Re: More dumb questions

To: spridgets@autox.team.net, bmantz@infi.net
Subject: Re: More dumb questions
Date: Wed, 13 Sep 2000 17:23:24 -0700 (PDT)
Bill,

The wrist pins for the 1275 are press fit into the rods, so they don't require 
circlips, or a new bushing.

 - Bryan
 
>X-Authentication-Warning: teamfat2.dsl.aros.net: majordom set sender to 
owner-spridgets@Autox.Team.Net using -f
>X-Accept-Language: en
>MIME-Version: 1.0
>To: "spridgets@autox.team.net" <spridgets@autox.team.net>
>Subject: More dumb questions
>
>I have to admit, I'm already a little suspicious since the shrink
>wrapped package only contained 7 connecting rod bearings. The
>instructions in the box with the new +.020 pistons states to always use
>new circlips. Sounds good to me, only the pistons have no groove for
>circlips and the wrist pin is the length of the bore, so if there was a
>groove, you couldn't use one. Does the 1275 engine #12cj/da/h 35710 have
>circlips on the wristpins? I'd check the old ones, but the machinist has
>them. If they don't should the small end bushing always be replaced when
>fitting net wrist pins.
>


<Prev in Thread] Current Thread [Next in Thread>