We've had the O2 sensor for BEEFI 'in the way' now for some time. Haven't
notice any power loss due to restriction (nor other problems). We're running a
stock, 1275 sized exhaust system.
WFO Herb
Keep the sticky side down!
mgraziano@mindspring.com wrote:
> I don't know that I would necessarily want mine in there all the time, but
>the sensor section (that sticks into the pipe), at least on my 3 wire Bisch
>unit, is a little shy of 3/4 of an inch deep, and 1/2 inch in diameter. Not
>too large. At least not enough to really worry about it. Performance
>shouldn't be affected too much.
>
> Mike
>
> Jeff Boatright <jboatri@emory.edu> wrote:
> > Lots of info about oxygen sensors at:
>
> http://www.howstuffworks.com/question257.htm
>
> After looking at the senor photos, it seems to me that you would not
> want one of those things installed permanently as there is quite a
> bit of sensor sticking out in the exhaust stream.
>
> _____________________________________________________________
> Jeffrey H. Boatright, PhD
> Assistant Professor, Emory Eye Center, Atlanta, GA, USA
> Senior Editor, Molecular Vision, http://www.molvis.org/molvis
> mailto:jboatri@emory.edu
|