Rick,
Be sure to check inside the float bowls --- check to see if there is a lot
of "gunk" in them (like rust colored powdery stuff). If so, they really
need to be cleaned up or rebuilt. Found a bearing in one of mine!
Good luck!
Sue
Rick Walters wrote:
> Hi guys,
>
> I have a pait of HS-2s that I would like to try on Puddles when I get
> her back on the road. Yep, that's right I'm pulling the Weber to see if
> I can get any better low end. Frankly, I'm a little concern about
> putting the 5-speed ina car that won't rev below 3500 RPM. That means
> on the freeway I'll be doning about 70 just to maintain R's. Cops don't
> seem to like this much. Unless someone has some extra R's in a can for
> me. I'm hoping the SU's will aid in my low RPM performance.
>
> My question is what should I check on the old carbs? The throttle shaft
> are tight, dampers click, and they look fair. Is there any orings or
> gaskets I need to replace before I install them?
>
> Rick
|