| To: | "Frank Clarici" <spritenut@Exit109.com>, <spridgets@autox.team.net> |
|---|---|
| Subject: | Re: Serious camber problem |
| Date: | Wed, 13 Dec 2000 18:31:32 -0000 |
| References: | <3A36DA8F.AA59CB42@exit109.com> <000b01c0649a$65553cc0$7364640a@internal.vgl.ucdavis.edu> <3A37070A.B75ABE28@exit109.com> |
Never seen one where the BOTTOM edge kicks out. Now, the UPPER edge is a different matter. Top trunnion is on the wrong way round (ie kingpin points up outboard of the end of the shocker arm so turn the casting 180 degrees) Fairly obvious one, but I thought I'd mention it as nobody else has so far. Bottom edge 'out'....no idea! Sorry. Rob |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | Anyone in North Texas..., Unknown |
|---|---|
| Next by Date: | High Cat Content (NO LBC), Unknown |
| Previous by Thread: | re: Serious camber problem, Unknown |
| Next by Thread: | Re: 4x4 alignment? no lbcx-mac-creator="4D4F5353", Unknown |
| Indexes: | [Date] [Thread] [Top] [All Lists] |