Hi Frank,
Thanks for the plywood info. The part of the torque wrench that normally
goes into a socket would be positioned right at the center of the spinner.
The plywood piece and it's adapter to the torque wrench would be analogous
to a giant socket wrench.
Mark
> -----Original Message-----
> From: Frank Clarici [SMTP:spritenut@exit109.com]
> Sent: Sunday, January 07, 2001 8:06 PM
> To: Hanna, Mark
> Cc: 'Spridgets@Autox.Team.Net'
> Subject: Re: UNDO torque ;-)
>
> "Hanna, Mark" wrote:
> >
> > When finished , My Sprite will have wire wheels. I would rather not
> pound on
> > the new UNDO's. It's bad for wheel bearings and the new knock-off
> spinners.
> > I saw a plywood tool that fits the external shape of the spinner to
> save
> > the chrome from being pounded on. I can easily build a tool to link my
> 100
> > ft/lb. torque wrench to this plywood piece. If I build this tool each
> > spinner will be tightened to the same value. the question is : What is
> the
> > correct torque ?
>
> I can tell you which plywood to use but I can't help with the torque.
>
> I do have a question though, wouldn't the torque reading be different if
> you have the wrench attached to a lever of wood?
> Sot of like the reverse of a cheater bar on a wrench.
>
> Oh BTW, use at least a 5 ply fir plywood, 3/4 AC would be best
>
> --
>
> Frank Clarici
> Toms River, NJ
> Too Many Sprites Again
|