FWIW Ted Schumacher (http://www.tsimportedautomotive.com/) regrinds cams. He
did mine, and Mike Graziano's. I opted for the TSI275-4 grind. I like it, a
bit lumpy at idle, but lot's o' ponies at full tilt.
Larry
At this exact moment in time 3/7/02 8:10 AM, "David N Waldmann"
<david@vermonthardwoods.com> made the profound statement:
>
> Regarding the cam, as I understand most of the aftermarket cams out there
> are reground stock ones. There may be a few ground from OEM blanks, and
> there are some billet ones (made from new steel). However, to have your cam
> reground is going to be a custom one-off job, and I can't imagine it would
> save any money over buying a production one. Of course, if you have produced
> your own design and want to have it ground (like Vizard does) by all means
> go ahead.
>
> <dnw>
> 1972 Midget, blowing smoke
> 1998 Safari
> 1999 9-3
> 1964 (Me)
> I enjoy long walks. Especially when they are taken by people who annoy me.
>
> ----- Original Message -----
--
Larry B. Macy, Ph.D.
macy@bbl.med.upenn.edu
System Administrator/Manager
Neuropsychiatry Section
Department of Psychiatry
University of Pennsylvania
3400 Spruce St. - 1015 Gates
Philadelphia, PA 19104
The bottom line: Sure, there's pain in adopting the Mac. But if I accept
that, I get to use a computer that works, and that pretty much does what I
expect and want a computer to do.
Stewart Alsop
FORTUNE.com
Monday, June 25, 2001
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/spridgets
|