[Top] [All Lists]

Re: Temp Sending unit

To: john donohoe <gt6driver@yahoo.com>, Spridgets@autox.team.net
Subject: Re: Temp Sending unit
Date: Mon, 3 Jun 2002 09:16:00 -0700

The place you describe is where the heater shut-off valve should be. Not
necessarily a bad place, but incorrect and so I wonder what tyoe od sender
you are using. The correct place is is in the right hand top of the
radiator. There is also a place in the cylinder head, but just in front of
the #1 spark plug.

How is your heater connected... ro is it?


At 7:38 AM -0700 6/3/02, john donohoe wrote:
>Hello all,
>I'm hoping to install a good temp gauge that will give
>me an accurate reading of the temp in my 948 Sprite
>The orignal sender lived in the top face of the head,
>at the back, right hand corner. The "bulb" itself does
>not look like it even quite touches the coolant!
>Any thoughts or experiences on better
>placement/different sending units?
>John Donohoe
>Yahoo! - Official partner of 2002 FIFA World Cup

Please visit Four Points Travel -
Discount Online International Travel Reservations
To make a reservation please call Toll Free 1-800-272-3253

G G              Gerard Chateauvieux
 E A
  R R        pixelsmith@gerardsgarage.com
   A A
    R G          Pixelsmith  on  Duty
     D E
      S      http://www.gerardsgarage.com

///  unsubscribe/change address requests to majordomo@autox.team.net  or try
///  http://www.team.net/mailman/listinfo
///  Archives at http://www.team.net/archive/spridgets

<Prev in Thread] Current Thread [Next in Thread>