In a message dated 6/4/02 12:09:45 AM Eastern Daylight Time,
> I have contemplated the notion of injecting the inside with "something" that
> will dry solid and flat as I mold it after shooting it in. Is this idea
> nuts, or has someone tried it already? If so what product did you use? I
> have considered using a can of "Great Stuff" foam insulation.
> If I replace the visors, my question would be - how do I attach them? What
> is that fastener, anyway?
- - - - - - - - - - -
The diagram in the Moss catalog shows the fasteners. Basically it is a nut
with a very strong spring under it. Moss sells all the fasteners and new
visors, and they aren't very expensive, as I remember. Go to
I put new visors on my '77 Midget, but then the hood clips were in the way
when the hood was up, so I couldn't see under the visors. I just took them
SCCA Philly Region Rally Steward
'75 Midget "The Project"
'92 Mitsubishi Expo LRV Sport
/// unsubscribe/change address requests to email@example.com or try
/// Archives at http://www.team.net/archive/spridgets