spridgets
[Top] [All Lists]

Re: Honda Wheels?

To: Gerard <pixelsmith@gerardsgarage.com>
Subject: Re: Honda Wheels?
Date: Thu, 27 Jun 2002 17:55:22 -0400
Cc: SDOliner@aol.com, spridgets@autox.team.net
References: <v03130328b94038661082@[209.209.93.154]> <v03130303b940f4478d69@[209.209.93.108]>
I figured it would be a thick spacer, and the fabrication time might not justify
the results.  I don't always have the most sensible ideas.  More a theory 
question
than anything else, I suppose.  It's not like I have this big cache of FWD 
wheels
lying around.

Jim

Gerard wrote:

> I'm no expert in this area, but one set I looked at had nealy 5" of
> backset. You'd need a spacer that was about 1.25 inches. Of course it
> depends on wheel width. Way too much and too much trouble too, if you ask
> me.
>
> Gerard
>
> At 11:07 AM -0400 6/27/02, Jim Juhas wrote:
> >Would it be possible to build a significantly thick spacer to use FWD
> >wheels on a
> >Spridget or other LBC?  It would seem to me that the proliferation of 
>"compact
> >sports" as defined by carlisle productions, there have to be a lot of wheels
> >turning up in the used market.
> >
> >Has anyone tried it?

///  unsubscribe/change address requests to majordomo@autox.team.net  or try
///  http://www.team.net/mailman/listinfo
///  Archives at http://www.team.net/archive/spridgets


<Prev in Thread] Current Thread [Next in Thread>