Here is a drawing of a Bugeye Bonnet front hinge.
http://www.ado13.com/project/hingedrawing.gif
Larry Miller
http://www.ado13.com
----- Original Message -----
From "bill b." <w_burrell at yahoo.com>
To: "spridget list" <spridgets@autox.team.net>
Sent: Friday, November 08, 2002 8:01 AM
Subject: Re:Tilt front end, 69 sprite
> > --- dmeadow@juno.com wrote:
> > > I've seen a couple of Spridget racers configured
> > > this way. It doesn't look too difficult. The
> > main
> > > challenge is to create the hinge on the front.
> >
> > Sounds like a way to go, not that hinging the whole
> > thing would be any easier than aligning the front
> > hinges that I am working on. But in the long run it
> > may be an overall better solution. Right now my
> > Sprite
> > is bumperless. I was going to put them back on for a
> > little more protection, but after looking at the
> > relationship between my pickup bumper and the Sprite
> > I
> > think it would take 3 foot tall bumper over-riders
> > to
> > do any good. I'm just prepared to park further out
> > in
> > the lots and walk in rather than try any kind of
> > bumpers. I am hoping someone on list may be able to
> > come up with some pictures or descriptions of the
> > hinges.
> >
> > cheers,(so many projects so little time and $) bill
> > b.
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/spridgets
|
