spridgets
[Top] [All Lists]

Re: Restoring an exhaust manifold

To: spridgets@autox.team.net
Subject: Re: Restoring an exhaust manifold
Date: Fri, 24 Jan 2003 14:19:52 -0500
References: <3E3151BD.49E03772@agr.state.ne.us> <3E3157E0.90603@exit109.com>
It didn't work for me, but maybe I was trying to fill too large of a void.

At 10:12 AM -0500 1/24/03, Frank Clarici wrote:
>In my pre glass bead cabinet days, I used a wire wheel on the bench
>grinder. That worked pretty good.
>I have heard (but can not confirm) that JB-Weld can be used as a bondo
>type filler on pock marks and pits on the exhaust manifold.
>Smear it on, sand it at just the right time before it gets too hard.
>I don't know if JB will hold up to exhaust manifold heat but somebody
>once told me it works. I never tried it myself.
>
>--
>Frank Clarici
>Toms River, NJ
>2 Sprites, 2 Midgets
>http://www.exit109.com/~spritenut


_____________________________________________________________
Jeffrey H. Boatright, PhD
Assistant Professor, Emory Eye Center, Atlanta, GA, USA
Senior Editor, Molecular Vision, http://www.molvis.org/molvis
mailto:jboatri@emory.edu

///  unsubscribe/change address requests to majordomo@autox.team.net  or try
///  http://www.team.net/mailman/listinfo
///  Archives at http://www.team.net/archive/spridgets


<Prev in Thread] Current Thread [Next in Thread>