It is called "Retaining Compound", they make it in at least two strengths.
Go for the stronger stuff.
BTW, you can get a machine shop to crosshatch the bearing seat on the
inside of the hub to help the sloppy fit and to get the retaining
compound to work a little better.
Mike
On Mon, 3 Mar 2003, Frank Clarici wrote:
> MGTD2@aol.com wrote:
> >
> > In such a circumstane, should I use some anaerobic bearing mount adhesive to
> > tighten up the fit
>
> Locktite makes something for this. It's green, I have it but it's too
> cold to go out and look at the bottle.
> I used it on my Sprite a couple years back with good results.
>
> --
> Frank Clarici
> Toms River, NJ
> 2 Sprites, 2 Midgets
> A car doesn't just take us places, it's a place all by itself.
> http://www.exit109.com/~spritenut
>
> /// Send your messages to spridgets@autox.team.net
> /// unsubscribe/change address requests to majordomo@autox.team.net or try
> /// http://www.team.net/cgi-bin/majorcool
> /// http://www.team.net/mailman/listinfo
> /// Archives at http://www.team.net/archive/
/// unsubscribe/change address requests to majordomo@autox.team.net or try
/// http://www.team.net/mailman/listinfo
/// Archives at http://www.team.net/archive/spridgets
|