spridgets
[Top] [All Lists]

Thread Cleanup

To: <spridgets@autox.team.net>
Subject: Thread Cleanup
Date: Wed, 18 Jun 2003 10:44:08 -0700
Thread-index: AcM1wVAhzZ62uWpJRhC9PJeXlvSmdA==
Thread-topic: Thread Cleanup
I need to clean the threads on the rear end to which the nut that holds
the wheel bearing in place attaches.  Is there a recommended tool?  It
is the drivers side, so it is reverse threaded.  In about 2 or 3
threads, it looks ok.  I have ordered a new nut which was at least half
the problem, but the first couple of threads look kinda bad, and it is a
sorta important nut to not have fall off.

Thanks,
Dan

///  unsubscribe/change address requests to majordomo@autox.team.net  or try
///  http://www.team.net/mailman/listinfo
///  Archives at http://www.team.net/archive/spridgets


<Prev in Thread] Current Thread [Next in Thread>