spridgets
[Top] [All Lists]

RE: It ain't Chinese; it ain't M*$$; and it still ain't right

To: SpridgetAssn@justbrits.com, "Spridgets Mail list" <spridgets@Autox.Team.Net>, "Geoff Branch" <gjbranch@comcast.net>
Subject: RE: It ain't Chinese; it ain't M*$$; and it still ain't right
Date: Wed, 29 Dec 2004 20:28:7 -0500
so like righta 'bout now ya ready fer da graphire grease answer?  
huh?-huh?-huh? are ya?

chuck.


> [Original Message]
> From: Geoff Branch <gjbranch@comcast.net>
> To: Spridgets Mail list <spridgets@Autox.Team.Net>;
<SpridgetAssn@justbrits.com>
> Date: 12/29/2004 7:56:05 PM
> Subject: It ain't Chinese; it ain't M*$$; and it still ain't right
>
> Crankshaft for the Perkins diesel I'm fighting with:
> 
> 1. Not machined correctly for  thrust washers
> 2. Counter weight bolt holes not deep enough
> 3. Front end has "spacer" machined into it with no instructions or
notices to
> that effect.....now the whole durn thing has to come apart....again.
> 
> And it's made in TURKEY!!!!!
> 
> On the other hand, it was only $300 and if I had to pay the $800 for the
> 'merican one, the tractor would have been pushed over the hill and
abandoned.
> 
> Geoff Branch
> '74 Meejit
> '72 Innocenti Mini
> '64





<Prev in Thread] Current Thread [Next in Thread>