I was just about to take the Sprite for some gas and a little ride this
morning and was stopped by a leaking Apple Hydraulics master cylinder. This
was my second one replaced under warranty. I took the thing apart to see why
they keep failing. The cylinder bores look like they were finished with the
roughest hone stone available, nothing will seal against this finish. Their
catalog said they are sleeved. This one looks like it hasn't been. I tried
calling them only to get a we are not in the office message. I'll try again
later. I just want my money back at this point!
I know it was mentioned in my last thread about this, but I just want to be
sure. Who is the best supplier for rebuilt units?
Alan
'59 Sprite
|