spridgets
[Top] [All Lists]

Re: overheating 1275

To: "Glen Byrns" <grbyrns@ucdavis.edu>, <spridgets@autox.team.net>
Subject: Re: overheating 1275
From: "Paul Asgeirsson" <pasgeirsson@worldnet.att.net>
Date: Mon, 14 Aug 2006 11:22:01 -0700
Hi Glen,

Glad that bit is sorted out.  But I was once plagued with an engine that
slowly went out of time.  Just a few degrees at a time, but after several
retimings it was runny really crappy.  What I found was the outer perimeter
of the harmonic balancer was loose on the rubber and was slowly moving!
That might be what's happening to yours.

I simply let mine alone until it started to move forward off the rubber and
then I robbed another Austin America of it's harmonic balancer.

Later, Paul A

----- Original Message ----- 
From: "Glen Byrns" <grbyrns@ucdavis.edu>
To: <spridgets@autox.team.net>
Sent: Monday, August 14, 2006 10:42 AM
Subject: overheating 1275


> Since I had put the mild 1275 into the Austin, it hadn't really acted like
> what I expected to be.  It tended to get pretty hot when run on the
freeway
> and at red lights.  It over-ran and occasionally misfired.
>
> Friday I jacked the timing waaay over toward what should have been too
> advanced according to the timing marks.  Well now it runs cool, mileage is
way
> up, power is way up, no misfires and no over-run.  Looks like the pained
notch
> timing mark on the harmonic balancer was meant to line up with some other
> pointer on some other timing cover.  Miracle cure!  Now that its too late,
the
> Austin is finally ready to drive down to BusterCluster.  Oh well, all that
> beer would have been a tight fit in the Austin.
>
> Glen




<Prev in Thread] Current Thread [Next in Thread>