spridgets
[Top] [All Lists]

Re: Cosmoline removal

To: Ron Soave <soavero@yahoo.com>
Subject: Re: Cosmoline removal
From: Larry Macy <lmacy@phillymgclub.com>
Date: Fri, 6 Apr 2007 22:39:56 -0400
Everything I ever touched when I worked for Waukesha engines (think  
Cat only bigger) was coated in cosmoline. We washed it off in SK  
sovent, or gas if no solvent was available. No loss of metal, ever.

Larry

On Apr 6, 2007, at 9:11 PM, Ron Soave wrote:

> So I'm popping some new bearings into a 1275 last
> night, they are NOS Vandervells slobbered in
> cosmoline. I do the first 2, cleaning with WD40 and
> lots of rag action. They mic perfectly, all seems
> good. I decide to try brake cleaner on the 3rd set,
> cosmoline comes right off, so does a little of the
> tri-metal!  Not good, so I pop in some Israeli
> tri-metals that are supposed to be pretty good instead
> (I hope). But the question is - what's good to clean
> off cosmoline? Should the brake cleaner have taken of
> the top coat of metal??? Were the NOS vandies too old?
>
> Ron
>

-- 

Larry B. Macy, Ph.D.
macy@bbl.med.upenn.edu
Senior IT Program Director
Neuropsychiatry Section
Department of Psychiatry
University of Pennsylvania
3400 Spruce St. - 10 Gates
Philadelphia, PA 19104

  Ask a question and you're a fool for three minutes; do not ask a  
question and you're a fool for the rest of your life.



-- 
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.




<Prev in Thread] Current Thread [Next in Thread>