spridgets
[Top] [All Lists]

Re: [Spridgets] universal joint

To: Andy Webster <a_d_webster@yahoo.com.au>,
Subject: Re: [Spridgets] universal joint
From: "de Brebisson, Cyrille (Calculator Division)" <cyrille@hp.com>
Date: Mon, 24 Sep 2007 13:00:23 +0000
Hello,

I ended up drilling a hole on one side in the bearing cups in the middle, and
used a punch to push the oposit bcup through the hole that goes through the U
joint cross.

You can also bank on the cups from one side using a hammer and the appropriate
socket (just as a spacer) to help push/disloge the oposit cup.

crille

-----Original Message-----
From: spridgets-bounces+cyrille=hp.com@autox.team.net
[mailto:spridgets-bounces+cyrille=hp.com@autox.team.net] On Behalf Of Andy
Webster
Sent: Monday, September 24, 2007 2:07 AM
To: spridgets-aus@yahoogroups.com; spridgets@autox.team.net
Subject: [Spridgets] universal joint

G'day

  Anyone have some tips on removing the (front) uni joint from the prop
shaft?

  It isn't keen on moving and it needs to make way for the new front yoke.

  Can I place a drift against the ends of the bearing cup and smack it good n
hard?

  Is there a better way?

  BTW...managed to move the engine/trans back far enough that a fan belt could
be convinced to pass between the balancer and front X-member.
  Thanks for the tips!


  Cheers
  Andy


---------------------------------
Sick of deleting your inbox? Yahoo!7 Mail has free unlimited storage. Get it
now.
_______________________________________________
cyrille@hp.com

Edit your replies

http://www.team.net/archive

http://autox.team.net/mailman/listinfo/spridgets
_______________________________________________

Edit your replies

http://www.team.net/archive

http://autox.team.net/mailman/listinfo/spridgets

<Prev in Thread] Current Thread [Next in Thread>