spridgets
[Top] [All Lists]

Re: [Spridgets] Sleeving master/brake cylinders - Stainless vs.

To: "David Riker" <davriker@nwi.net>
Subject: Re: [Spridgets] Sleeving master/brake cylinders - Stainless vs.
From: "Brad Fornal" <tequila.brad@gmail.com>
Date: Thu, 19 Jun 2008 21:31:01 -0500
If I may, I'll address each of your points..

On Thu, Jun 19, 2008 at 9:23 PM, David Riker <davriker@nwi.net> wrote:

> Every time I have had a 1275 equipped spridget with a clutch that would not
> fully disengage it was due to wear at any and all mechanical points along
> the way and never due to a failure of the master or slave cylinder.
> 1. Worn hole in top of clutch pedal

Yes, slightly worn, BUT, it was working fine BEFORE the rebuild

>
> 2. Worn clevis pin at clutch pedal to master cylinder push rod

NEW

>
> 3. Worn hole in clutch master cylinder push rod

NEW

>
> 4. Worn clevis pin at clutch slave cylinder

LIKE NEW, NO WEAR

>
> 5. Worn hole in clutch release arm

NEW

>
> 6. Worn bushings on clutch release arm pivot.

NEW

>
> 7.  Worn carbon throw out bearing

NEW

>
> 8.  Worn fingers on the clutch pressure plate

NEW

>
> 9.  Old flex hose that "balloons" under pressure.

NEW

>
>
> These weak points all tend to wear out at the same rate, and fixing only
> one of them will not solve the problem.  They must all be renewed at the
> same time.
>
> The slave cylinder from a 1098 is a smaller bore, and can be substituted
> for the correct one on a 1275.  Because the bore is smaller, the same amount
> of pedal travel will result in more travel of the clutch release arm.

THIS WON'T WORK, AS THE LINE COMING INTO THE 1098 IS SMALLER THAN THE 1275
FLEX LINE

>
> David Riker
> ----- Original Message ----- From: "Guy Weller" <guy.weller@tiscali.co.uk>
> To: <Weslake1330@aol.com>; <tequila.brad@gmail.com>; <dlh2001@comcast.net>
> Cc: <spridgets@autox.team.net>
> Sent: Thursday, June 19, 2008 3:50 AM
> Subject: Re: [Spridgets] Sleeving master/brake cylinders - Stainless vs.
> Brass
>
>
>  Fitting a longer pushrod may help, but do be careful not to "overthrow"
>> the
>> clutch.  That is, to overcompress the clutch cover fingers which can then
>> distort and destroy the clutch.
>> The distance that the clutch mechanism moves between fully released and
>> full
>> compressed is not actually controlled by the length of the slave pushrod,
>> but by the amount of fluid displaced when you press the pedal.
>>
>
>


-- 
DON JULIO 1942

www.myspace.com/tequilabrad
_______________________________________________
Support Team.Net  http://www.team.net/donate.html


http://www.team.net/archive

http://autox.team.net/mailman/listinfo/spridgets

<Prev in Thread] Current Thread [Next in Thread>