--===============0739230367==
Content-Type: text/plain; charset="windows-1250"
Content-Transfer-Encoding: 7bit
Leo,
If it is an electrical misfire then the tachometer needle will thrash
around. If it is fuel / vapour lock etc then the revs will drop as it
misfires but the needle won't thrash about so much.
But it could be valves sticking as they get hot. Is it a standard camshaft
and what clearance are you running the tappets at?
Guy
-----Original Message-----
From: spridgets-bounces+guy.weller=tiscali.co.uk@autox.team.net
[mailto:spridgets-bounces+guy.weller=tiscali.co.uk@autox.team.net]On Behalf
Of Bill L
Sent: 09 July 2008 05:08
To: Leo
Cc: spridgets@autox.team.net
Subject: Re: [Spridgets] Fuel take carbon and vapor filters
Hello Leo,
I too am leaning toward coil. 10 minutes shouldn't be long enough
to vapor lock it, I would think. however it is long enough for
the coil to heat up and start acting .... ODD...
and its an easy enough thing to check. Swap coils .. i've heard
of the coil being broken not enough to see right where the the
low tension leads connect.... .. ALSO .. CHANGE the CONDENSOR!
that too will cause similar problems, and the only way to check
it is to change it....
--
Best regards,
Bill L. mailto:pythias@pacifier.com
'66 Sprite MKIII HAN8L49403 "the red thing"
File not found. Should I fake it? (Y/N)
--===============0739230367==
Content-Type: text/plain; charset="us-ascii"
MIME-Version: 1.0
Content-Transfer-Encoding: 7bit
Content-Disposition: inline
_______________________________________________
Support Team.Net http://www.team.net/donate.html
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
--===============0739230367==--
|