spridgets
[Top] [All Lists]

Re: [Spridgets] Metal repair*

To: Adrian Jones <adrianjones747@earthlink.net>,
Subject: Re: [Spridgets] Metal repair*
From: dlancer7676@comcast.net
Date: Tue, 15 Jul 2008 12:31:54 +0000
I went to a local metal supplier and bought a sheet, about 4 x 6 or so, of 
sheet metal, 18 guage.   From that you can cut any shape or size you want.  I 
suspect you could get a smaller piece, since they cut this one for me from a 
larger sheet of metal.  i was replacing a lot of metal so needed a bigger sheet.

If you have someone who is a really good welder, the butt weld is the choice 
here because a lap weld, where you crimp the piece to fit into the hole, 
provides a place for water to hang out.  That is a bad thing. Another option 
available now is to crimp the piece to fit and use an epoxy that is available 
for patching.  You fit the patch, drill holes around the perimeter to accept 
pop rivets, lather the patch edges up with the epoxy, then pop rivet the patch 
into place.  It comes with a syringe that has a special nozzle that mixes the 
epoxy as it travels through the nozzel.  I used that on my bonnet and it turned 
out very well.  The epoxy seals the gap between the metal created by the lap 
joint.  bondo over the patch and finishing created a non-perceptable joint.  I 
got that at a paint and body supplier.

Of course, with either method, you have to be absolutely sure that the rust 
that you are SEEING is all the rust you have, which has not been my experience. 
 Rust is sort of like mice. If you see one, count 20.    8^)

--David C.
WOULD A FLY WITHOUT WINGS BE CALLED A WALK?


 -------------- Original message ----------------------
From: Adrian Jones <adrianjones747@earthlink.net>
> OK, some bonehead questions:
> 
> Frank Clarici wrote:
> bCut the rust out completely, try to make a nice square hole, cut a piece
> of sheetmetal about 1 inch largerb
> 
> Where would you go for this sheetmetal and what do you ask for (type of metal
> and thickness)?
> 
> bOr you can buy a sill and just cut out the part you needb
> 
> What kind of a joint would you make between new and old?
> 
> Thanks in advance for advice.
> 
> Cheers,  Adrian
> _______________________________________________
> Support Team.Net  http://www.team.net/donate.html
> 
> You are subscribed as dlancer7676@comcast.net
> 
> http://www.team.net/archive
> 
> http://autox.team.net/mailman/listinfo/spridgets
_______________________________________________
Support Team.Net  http://www.team.net/donate.html


http://www.team.net/archive

http://autox.team.net/mailman/listinfo/spridgets

<Prev in Thread] Current Thread [Next in Thread>
  • Re: [Spridgets] Metal repair*, dlancer7676 <=