spridgets
[Top] [All Lists]

Re: [Spridgets] Clutch carbon bearing

To: Weslake1330@aol.com,jlaird237@cox.net,mail4carpenters@peoplepc.com,
Subject: Re: [Spridgets] Clutch carbon bearing
From: Peter C <peter@nosimport.com>
Date: Tue, 05 Aug 2008 14:08:37 -0500
Oooh, ooooh.... I do, I do..

948 1/2" from center of peg to face of carbon
1098 3/4"
1275  .970"

Peter C.
===
At 01:56 PM 8/5/2008, Weslake1330@aol.com wrote:
>So, does anyone know what the difference is between the 948/1098 bearing  and
>the 1275 bearing?
>
>In a message dated 05/08/2008 19:15:30 GMT Daylight Time, jlaird237@cox.net
>writes:
>
>Tis my  opinion, from experence, that some clutch sets are improper, ie the
>throw  out bearing is thiner by 1/4 inch than it should be. Some others have
>something else wrong with them that I don't understand. I have had both
>problems.
_______________________________________________
Support Team.Net  http://www.team.net/donate.html


http://www.team.net/archive

http://autox.team.net/mailman/listinfo/spridgets

<Prev in Thread] Current Thread [Next in Thread>