spridgets
[Top] [All Lists]

Re: [Spridgets] Vega Wheels

To: Dean Hedin <dlh2001@comcast.net>
Subject: Re: [Spridgets] Vega Wheels
From: Linda Grunthaner <grunthaner@gmail.com>
Date: Fri, 6 Feb 2009 10:12:50 -0500
Very cool so where would be the best place to look for inexpensive Vega
Mags?
Lin

On Thu, Feb 5, 2009 at 11:38 PM, Dean Hedin <dlh2001@comcast.net> wrote:

> There is one more issue.
> The center hole is not large enough.
> You have to either enlarge the center hole or run 1/4"
> spacer plates between the rims and the hub.
>
> At least this was the case with the steel Vega wheels
> I once had.
>
> They did not look too bad.  I always thought a little moon
> hubcap on them would look good.   But I never found anything
> that would fit.
>
> ----- Original Message ----- From: "David Lieb"Subject: Re: [Spridgets]
> Morris truck photos
>
>
>  Does this mean all Vega wheels fit the Spridgets too?
>>>
>>
>> Lin,
>> Yes, Chevy Vega (and Monza) wheels are some of the few that share the
>> 4-on-4" bolt pattern of the Spridget. Vega GT wheels are especially nice for
>> autocrossing as they are 6" wide. OTOH, If you choose to run Vega wheels, do
>> NOT use the stock (11/16" socket) Spridget lugnuts as these will tear right
>> through the holes. The after-market lugnuts for Minitors (13/16" socket)
>> work well.
>> David
_______________________________________________
Support Team.Net  http://www.team.net/donate.html


http://www.team.net/archive

http://autox.team.net/mailman/listinfo/spridgets

<Prev in Thread] Current Thread [Next in Thread>