spridgets
[Top] [All Lists]

Re: [Spridgets] measurement needed (Bugeye)

To: "Jim F." <jimndi@frontiernet.net>
Subject: Re: [Spridgets] measurement needed (Bugeye)
From: Frank <spritenut@comcast.net>
Date: Mon, 09 Mar 2009 22:00:37 -0400
Jim F. wrote:
> Well it just needs to be wide enough to carry the locking pins, right? 
> put the two rods together with a little grease on them, and thats your 
> width.
>
If I had one here to look at, I could figure out something.
When there is nothing there, it's just a bit tough.
I think I have to look at a decent bonnet in person as I think mine is 
missing too many parts down there.
Locating pegs, where did they go?
Holes for the twist latch, what holes, there is no metal there.

_______________________________________________
Support Team.Net  http://www.team.net/donate.html


http://www.team.net/archive

http://autox.team.net/mailman/listinfo/spridgets

<Prev in Thread] Current Thread [Next in Thread>