spridgets
[Top] [All Lists]

Re: [Spridgets] I hate U joints

To: Frank <spritenut@comcast.net>
Subject: Re: [Spridgets] I hate U joints
From: "rrengineer @dslextreme.com" <rrengineer@dslextreme.com>
Date: Sun, 29 Mar 2009 19:21:15 -0700
I have a drive line shop a few miles from my house.  They will replace
U-joints AND balance the drive shaft cheap.  No aggravation on my part.  I
could not install a U-joint to save my life.  Sometimes a man just has to
know his limitations... I think I heard that somewhere before. ;^)
Mike MacLean
60 Sprite
56 BN2

On Sun, Mar 29, 2009 at 7:16 PM, Frank <spritenut@comcast.net> wrote:

> Ever since I was 18 and owned a shitfire that needed U joints once a week,
> I hated them
> I hate replacing U joints so much that I am forever using good used
> driveshafts in any Sprite I restore.
> Well I am out of good used shafts BUT I had a pair of U joints and a few
> driveshafts to beat apart.
> So why is it EVERY FREAKING time a needle bearing drops and screws up my
> new U joint?
> I have tried several different methods of pressing them in, beating them
> in, dropping the knuckle into the cap and every single time I mess up at
> least one cap by dropping a needle bearing.
> Tonight was no exception, 2 new joints, 2 now with one cut needle each.
> (quality Japanese steel)
> Yes made in Japan on the box. Imagine chinese U joints? I can't.
> From now on I will just take the drive shafts to the machine shop, it just
> not worth the aggravation.
> You would think someone would come up with a better U joint. No needle
> bearings or at least have them retained somehow.
>
> --
> Frank Clarici
> Toms River, NJ
> My own Fleet of Sprites
> _______________________________________________
_______________________________________________
Support Team.Net  http://www.team.net/donate.html


http://www.team.net/archive

http://autox.team.net/mailman/listinfo/spridgets

<Prev in Thread] Current Thread [Next in Thread>