GUY DAY wrote:
> Frank,
> Try wiping the inside of the joint, over the needles, with a goodly
> layer of thick(ish) grease before assembly. You're going to pump them
> full through the zerk (grease nipple) anyway. Don't hammer them
> together, the needles fall out (LOL!). 'G' clamp if still under the
> motor and in the vice if off.
> Thanks Guy, that is exactly what I do, and on the bench in a vise.
The needles still fall over and keep the snap ring from fitting in the
groove.
I hate U joints, always did.
--
Frank Clarici
Toms River, NJ
My own Fleet of Sprites
_______________________________________________
Support Team.Net http://www.team.net/donate.html
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
|