spridgets
[Top] [All Lists]

Re: [Spridgets] oil for spridgets

To: Billy Zoom <billyzoom@billyzoom.com>
Subject: Re: [Spridgets] oil for spridgets
From: Jim Johnson <bmwwxman@gmail.com>
Date: Thu, 23 Jul 2009 17:24:40 -0500
Per my telcon with them yesterday evening and per their website:  "*The
Penn-Grade 1. oils typical 1,500 ppm Zinc (Zn) and 1340-1400 ppm
Phosphorus (P)*"

Whatever....

Cheers!!
Jim

On Thu, Jul 23, 2009 at 5:16 PM, Billy Zoom <billyzoom@billyzoom.com> wrote:

> Pre-1997 amount was 1600ppm.
> Brad Penn oil is 800ppm.
>
> > More is not always better. ZDDP is also a corrosive. Flat tappet cams
> > seem to like that 1200-1400 ppm. Go over that amount (like dumping too
> > much red-bottle STP into your 20-50 GTX) and you swing the pendulum the
> > other way.
> >
> > Easiest insurance: use oil formulated for aircooled motorcycles.
> >
> > Only a little less easy: use Brad Penn which you can get by UPS or, if
> > you happen to live near a distributor or race shop, right out the back
> > door.
> _______________________________________________
> Support Team.Net  http://www.team.net/donate.html
>
> You are subscribed as bmwwxman@gmail.com
>
> http://www.team.net/archive
>
> http://autox.team.net/mailman/listinfo/spridgets
>



--
Cheers!!
Jim
Only two things are infinite, the universe and human stupidity, and I am
not
sure about the former. - Albert Einstein
_______________________________________________
Support Team.Net  http://www.team.net/donate.html


http://www.team.net/archive

http://autox.team.net/mailman/listinfo/spridgets

<Prev in Thread] Current Thread [Next in Thread>