Okay, I'm getting going on the Midget. Never having done some of this stuff
before, I have a few questions which may be pretty elementary for a lot of
you but they are things I've simply never been involved with before.
I have a small compressor - a Clarke AC2000A - 2HP, 6 Gal tank which does
5.0 CFM at 90 PSI. Too small to drive high volume tools, but OK for smaller
stuff and for painting. It came with some really flimsy 1/4 inch yellow air
hose that is all coiled up. When you pull the coil out, it pinches off the
flow. I want to replace the hose with some better stuff. I'm wondering how
hard it would be to go up to 3/8 ID air hose. Any thoughts welcome on
this....
--
Cheers!!
Jim
Only two things are infinite, the universe and human stupidity, and I am
not
sure about the former. - Albert Einstein
_______________________________________________
Support Team.Net http://www.team.net/donate.html
http://www.team.net/archive
http://autox.team.net/mailman/listinfo/spridgets
|