No problems with the floats that I know of. I did just have to buy a new
needle
(and bowl gasket) for my Honda 400EX quad due to ethanol, though. The
float
needle in this carb has a pointed rubber end that seals against a metal
seat.
The ethanol pump gas I've been running hardened the rubber to the
point that it
did not seal. This meant that as long as the fuel was on, a
steady stream was
pouring out. Probably not an issue while running, but
somtimes I forget to turn
off the fuel when we stop on a ride and it's not
the safest thing to have gas
pouring out. And you definitely don't want to
forget about it after loading onto
the truck.
David Booker
Long Island
________________________________
From: Woerpel <dwoerpel@wi.net>
To: SPRIDGETS
<spridgets@autox.team.net>
Sent: Mon, December 20, 2010 12:40:51 PM
Subject:
Re: [Spridgets] Weather
Anyone had a problem with the plastic or styrofoam
floats and ethanol or
other additives?
Dave W.
On 12/20/2010 10:56 AM, Ron
Soave wrote:
> I've never had a problem. I will begin an immersion test
tonight along with
>another I have had brewing for a few weeks (synthetic
DOT4 on seals).
>Mythbusters Midwest Edition.
>
> --- On Mon, 12/20/10,
an5.sprite@gmail.com<an5.sprite@gmail.com> wrote:
>
>> From:
an5.sprite@gmail.com<an5.sprite@gmail.com>
>> Subject: Re: [Spridgets] Weather
>> To: "David Lieb"<72spridget@gmail.com>, spridgets-bounces@autox.team.net,
>>dwoerpel@wi.net, "spridgets"<spridgets@autox.team.net>
>> Date: Monday,
December 20, 2010, 10:36 AM
>> Ouch, I never new that, and just
>> poured
stabil into my tank. Does anyone know if it will it
>> harm aeroquip hoses?
>>
>> Steve
>> Sent from my Verizon Wireless BlackBerry
>>
>> -----Original
Message-----
>> From: David Lieb<72spridget@gmail.com>
>> Sender:
spridgets-bounces@autox.team.net
>> Date: Mon, 20 Dec 2010 10:25:29
>>
To:<dwoerpel@wi.net>;
>> Spridgets<spridgets@autox.team.net>
>> Subject: Re:
[Spridgets] Weather
>>
>> Yes, Sta-bil will EAT any rubber pieces it sits in
contact
>> with. S
>> Dave says, the bowl gaskets on the H1 are the prime
>>
example. When you
>> get it out of storage and it sounds like it is running on
>> one carb
>> (idles ok, but undriveable), order up two new sets of the
>>
gaskets and
>> replace them.
>> David L
>>
>>
>>> My .05 worth: I used to
fill the tank and put in
>> Sta-bil in the bugeye
>>> and MGA and every 3
months would have to change the
>> rubber float bowl
>>> gaskets on the H1
carbs. If you don't have any
>> rubber pieces you should
>>> be OK. Now I
just fill the tank and park it
>> until May and I haven't had
>>> to change
gaskets in 2 years. Presently, I drive
>> 6 miles to get Premium
>>> w/o
alcohol. Will have to see what the proposed
>> E15 fuel will do.
_______________________________________________
Donate:
http://www.team.net/donate.html
Suggested annual donation $12.75
Archive:
http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe/Manage:
http://autox.team.net/mailman/options/spridgets/tncarnut1@yahoo.com
_______________________________________________
Donate: http://www.team.net/donate.html
Suggested annual donation $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|