[Spridgets] Working on the car, this time for real!

[corvallis at peoplepc.com (corvallis at peoplepc.com)]

No libating while working on Spridget; both of you may suffer.
Celebrate the end of each day away from the Sprite.  ...bill in corvallis
==================================================
-----Original Message-----
From: Andrew Payne [mailto:andrewpayne at intrex.net] 
Sent: Monday, August 01, 2011 6:24 PM
To: corvallis at peoplepc.com; spridgets-bounces at autox.team.net; Spridgets
Subject: Re: [Spridgets] Working on the car, this time for real!

After much investigation, and ingest-libation I have determined that I will
proceed. My two questions at this point are these: 
Where should I put the stands once I remove the rear suspension?
Many of the vertical panels have rust only at the very bottom-think wet
carpet dimensions-so the tabs are unusable. Should I use some angle steel
sections, or is there a better route?
Drew
Sent from my Verizon Wireless BlackBerry