Howard,
I may be wrong about the bushings having a metal casing inside. (I
might be confusing them with the front bushings for the rear
springs). The last set I installed did not have metal in the center
of the bushing, they were poly bushings and could be melted out if
necessary. So, melting them out just may work ;)
Kevin
On Jan 1, 2012, at 10:14 PM, Miniac7 at aol.com wrote:
> Yes indeed, the inner fulcrum pins (bolts), both front and rear on
> the left hand side.
>
> Howard
>
>
>
> In a message dated 1/1/2012 10:07:56 P.M. Eastern Standard Time,
> kevinv1275 at gmail.com writes:
> Howard,
>
> Are you talking about the inner fulcrum pins? At the inboard end of
> each A-arm?
>
> If so, I have had to cut them off with a reciprocating saw on several
> occasions. Heating them usually only melts the bushings and they are
> still stuck to the metal portion of the bushings which will not pass
> thru the holes in the A-arm. Spraying them with liberal amounts of
> PB Blaster or Liquid wrench sometimes helps......
>
> Kevin
|