spridgets
[Top] [All Lists]

[Spridgets] Metalurgical bearing type question

Subject: [Spridgets] Metalurgical bearing type question
From: guy at weller-lakes.co.uk (Guy Weller)
Date: Sun, 22 Apr 2012 23:01:40 +0100
Sounds like you are describing Lawrence's Frontline upper suspension arm
bushes

-----Original Message-----
From: spridgets-bounces at autox.team.net
[mailto:spridgets-bounces at autox.team.net]On Behalf Of
WeslakeMonza1330 at aol.com
Sent: 22 April 2012 22:36
To: cosmicmag1380 at gmail.com
Cc: spridgets at autox.team.net
Subject: Re: [Spridgets] Metalurgical bearing type question


Hi Kent,

The bush sits in a steel housing which itself isn't fantastically
expensive.  A bolt passes through the middle of the bush to clamp to
another steel
part.

Currently the wear is that the bolt isn't as tight a fit in the bearing as
I'd like due to a combination of average tolerances so I'm guessing over
time  the bolt hole opens up and there's more free play than there used to
be
along  with an MOT/inspection fail.

I don't think that either Oilite or Phospher bronze can be readily heat
treated.

Regards


In a message dated 22/04/2012 20:18:31 GMT Daylight Time,  cosmi
cmag1380 at gmail.com writes:

The  different alloys that you mention can be made harder or softer
depending on  the percentage of materials that you combine... Do you
have a particular  BHN or Rockwell hardness in mind? The consideration
here is the parts that  the bushing mates. A harder bush may damage the
other parts which, in turn,  may be more expensive and/or difficult to
replace!

Have you thought  about heat treating with water/oil cooling or
cryogenic treatment of the  parts that you have? If the stock part has
not been treated in some manner,  either process should give it extra
life. Water cooling a heated metal can  increase it's BHN by a fair
percentage. Oven heat treating with water  quenching does a really good
job of bringing the BHN up.

I have a  freind who owns a tool & die shop. He now has every piece
that he makes  cryogenically treated. He says that they last much, much
longer since he  started doing that.
--
Kent
1960 Bugeye
1983 Garage full of  spridget parts!
2010 Arrow shed full of excess spridget  parts!!!
------------------------

spridgets at autox.team.net

Donate: http://www.team.net/donate.html
Suggested annual donation: $12.75

Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe/Manage:
http://autox.team.net/mailman/options/spridgets/guy at weller-lakes.co.uk
No virus found in this incoming message.
Checked by AVG - www.avg.com
Version: 9.0.927 / Virus Database: 271.1.1/4952 - Release Date: 04/22/12
07:34:00

<Prev in Thread] Current Thread [Next in Thread>