[Fwd: Re-built Hydraulics]

[Steve Laifman <laifman@flash.net>]

This is a multi-part message in MIME format.
--------------215482457834F66163FEAFD3



--
Steve Laifman         < Find out what is most     >
B9472289              < important in your life    >
                      < and don't let it get away!>

_/_/_/_/_/_/_/
     _/                 _/_/_/       _/_/_/       _/
    _/        _/      _/     _/     _/    _/     _/_/_/_/
   _/        _/       _/    _/      _/  _/      _/
  _/_/_/_/_/__/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/
                         _/
                    _/_/_/


--------------215482457834F66163FEAFD3
Content-Disposition: inline

X-Mozilla-Status2: 00000000
Message-ID: <3738F53F.1D030701@flash.net>
Date: Tue, 11 May 1999 20:28:01 -0700
From: Steve Laifman <laifman@flash.net>
X-Mailer: Mozilla 4.51 (Macintosh; U; PPC)
X-Accept-Language: en
MIME-Version: 1.0
To: FRANK_BONIFAZI@HP-FtCollins-om4.om.hp.com
Subject: Re: Re-built Hydraulics
References: <H00016cf0b75b5cc@MHS>

Frank,

I am sure you saw the post on the source for grease.  The failure you
are experiencing is probably that shaft seal to the piston.  A re-sleeve
of just that bore is said to allow a tighter squeeze on the replacement
shaft seal.  I'd also check the shaft for scratches or wear.

Steve

--
Steve Laifman         < Find out what is most     >
B9472289              < important in your life    >
                      < and don't let it get away!>

_/_/_/_/_/_/_/
     _/                 _/_/_/       _/_/_/       _/
    _/        _/      _/     _/     _/    _/     _/_/_/_/
   _/        _/       _/    _/      _/  _/      _/
  _/_/_/_/_/__/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/_/
                         _/
                    _/_/_/



--------------215482457834F66163FEAFD3--