Doug,
I installed that very coil right back in the stock location on the Intake.
You still need the resistor if you are running points though just like me.
Regards,
Tim Ronak
-----Original Message-----
From: Doug Clark [mailto:dougmclark@hotmail.com]
Sent: Tuesday, June 06, 2000 6:27 PM
To: tigers@autox.team.net
Subject: Coil
Hi gang,
I've recently purchased a new coil. The coil is a MSD
Blaster Hi-Vibration
coil part #8222. My question is, do I still need to use the
stock resistor?
Or can this new coil take 12volts. The rest of the ignition
system is stock.
Has anyone added this coil, while leaving the rest of the
ing. sys. stock?
Thanks
Doug C
________________________________________________________________________
|