tigers
[Top] [All Lists]

Re: A-Arm Bushings and Ball Joints

To: Theo Smit <theo.smit@intel.com>
Subject: Re: A-Arm Bushings and Ball Joints
From: Larry Paulick <larry.p@erols.com>
Date: Tue, 15 Aug 2000 18:10:54 -0400
Theo, why not use a brake honing tool to lightly hone the inside of the
steel bushings.  This will not take of too much material, and by
controlling the hone, with its adjuster, you can get a good
hone/diameter for the new delrin bushing to fit nicely.  

Good Luck

Larry

<Prev in Thread] Current Thread [Next in Thread>